#1 2026-09-21 20:15:33

matmutant

Member

Registered: 2016-07-19

Posts: 41

Website

back in business, and troubles

Hi everyone, hope everything's good on your sides!
There's a loooooong time i didn't post out there: last i had a device running Bunsenlabs was my old ASUS  1011PX.

I am writing from Panasonic FZ-M1 with an iKey keyboard, but I can't say it went that smooth as for the install:

Standard install failed because I couldn't load the proper wifi firmware: installer was complaining that iwlwifi-8265-22 to 36 were missing but i couldn't find any but 34 and 36 and it couldn't seem to get grabbed from the drive i've put them on.

As wifi was working out of the box on the live USB, I did not gave up there and tried the netinstall method from a barebone Debian as documented, for which wget got a 404 for some reason

wget https://github.com/bunsenlabs/bunsen-netinstall/archive/carbon.tar.gz

Strangely enough i  could get it from another device, put it on a drive, mounted and cp it to ~/
Install went smoothly from  there.

Next steps for me are :
1/ Find a way to enhance tablet mode (enabling on screen  kb, finding a way to trigger right click by touch)
2/ increase scaling a little
3/ checking if everything works properly (BT, camera, etc)

Sector11

Mod Squid Tpyo Knig

From: Upstairs

Registered: 2015-08-20

Posts: 8,403

Re: back in business, and troubles

Welcome back.  Good luck.

---

Debian 13 Beardog hosted by SoxDog
Still a Conky 1.9er at heart.

matmutant

Member

Registered: 2016-07-19

Posts: 41

Website

Re: back in business, and troubles

Thank  you,

A little update on the topic :
- Bluetooth, mobile broadband are working flawlessly.
- Got gestures/scrolling with

export MOZ_USE_XINPUT2=1

in .Xsessionrc and touchegg
- Increased DPI a little with

Xft.dpi=120

in ~/.Xresources

sooooo, seems this little 7" tablet is liking Bunsenlabs a lot!