#1 Today 20:15:33

matmutant

Member

Registered: 2016-07-19

Posts: 40

Website

back in business, and troubles

Hi everyone, hope everything's good on your sides!
There's a loooooong time i didn't post out there: last i had a device running Bunsenlabs was my old ASUS  1011PX.

I am writing from Panasonic FZ-M1 with an iKey keyboard, but I can't say it went that smooth as for the install:

Standard install failed because I couldn't load the proper wifi firmware: installer was complaining that iwlwifi-8265-22 to 36 were missing but i couldn't find any but 34 and 36 and it couldn't seem to get grabbed from the drive i've put them on.

As wifi was working out of the box on the live USB, I did not gave up there and tried the netinstall method from a barebone Debian as documented, for which wget got a 404 for some reason

wget https://github.com/bunsenlabs/bunsen-netinstall/archive/carbon.tar.gz

Strangely enough i  could get it from another device, put it on a drive, mounted and cp it to ~/
Install went smoothly from  there.

Next steps for me are :
1/ Find a way to enhance tablet mode (enabling on screen  kb, finding a way to trigger right click by touch)
2/ increase scaling a little
3/ checking if everything works properly (BT, camera, etc)