You are not logged in.

#1 2016-07-08 02:23:03

jedichris816
New Member
Registered: 2016-02-26
Posts: 4

BunsenLabs Running Off MicroSD Card

I boot Bunsenlabs from my Micro SD Card.  Works well.  Only issue I seem to have is that when my laptop goes into hibernation/sleep, the MicroSD slot or the MicroSD itself either unmounts or stops communicating upon "resume".  So at this point I'm prompted with entering my username and password to "resume" the desktop session, however the password fails, then the system freezes.  It seems the system doesn't recover from hibernation/sleep properly, therefor I don't have access to the Bunsenlabs filesystem on the SD Card.  I then have to power off my laptop, and power on, then boot back into Bunsenlabs.  Aside from the power management options, which I have configured to never suspend/hibernate/sleep, is there a way to stop the SD Card from unmounting or hibernating/suspending/sleeping?  A config file setting?  Thanks.


Not sure if this helps, but here's my USB devices.  I think the MicroSD slot uses USB tech.

jedichris816@BunsenLabs-Linux:~$ lsusb
Bus 002 Device 002: ID 8087:8000 Intel Corp.
Bus 002 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 001 Device 002: ID 8087:8008 Intel Corp.
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 004 Device 002: ID 05e3:0747 Genesys Logic, Inc.
Bus 004 Device 001: ID 1d6b:0003 Linux Foundation 3.0 root hub
Bus 003 Device 003: ID 8087:07da Intel Corp.
Bus 003 Device 002: ID 174f:1474 Syntek
Bus 003 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub

Last edited by jedichris816 (2016-07-08 02:24:37)

Offline

#2 2016-07-08 03:34:40

Horizon_Brave
Operating System: Linux-Nettrix
Registered: 2015-10-18
Posts: 1,473

Re: BunsenLabs Running Off MicroSD Card

Hi and welcome!

What's the output of the 'mount' command, before it hibernates?

And What laptop is this?

The output of lspci may help as well...

Lastly, check your journalctl log upon the next boot to see if it has anything of interest.


"I have not failed, I have found 10,000 ways that will not work" -Edison

Offline

Board footer

Powered by FluxBB