You are not logged in.

#1 2022-05-12 21:36:36

emevillasenor
Member
From: Colima, México
Registered: 2022-05-12
Posts: 6

How to add a new entry to jgmenu on BunsenLabs GNU/Linux 10.5 Lithium

1. Open Terminal
2. Type and run.

sudo geany .config/jgmenu/prepend.csv

3. In this file you can see several ^sep(), each of these represents a menu divider, you can add an entry before or after these dividers using the following logic:

Label, Command to run the software

4. Example:

Spotify, spotify --no-zygote

5. Save your changes and done wink

Offline

#2 2022-05-12 22:46:14

rbh
Moderator
From: Sweden/Vasterbotten/Rusfors
Registered: 2016-08-11
Posts: 1,509

Re: How to add a new entry to jgmenu on BunsenLabs GNU/Linux 10.5 Lithium

emevillasenor wrote:

sudo geany .config/jgmenu/prepend.csv

Omit sudo. No need to run as sudo when changing your own configfiles.
You can also use entry in jgmenu: Preferences => Jgmenu => Edit menu content.

We have good documentation of jgmenu: Menu => Help & Resources => Basic Introduction to jgmenu on BL Lithium and  Menu => Help & Resources => Tutorials.


// Regards rbh

Please read before requesting help: Guide to getting help,
Introduction to the Bunsenlabs Lithium Desktop and other help topics under "Help Resources" on the BunsenLabs menu

Offline

Board footer

Powered by FluxBB