#1 2020-03-24 23:27:37

raksasas

New Member

Registered: 2015-10-22

Posts: 4

Audio defaults to "Analog Stereo Output" after every reboot.

How do i set my audio to always default to the HDMI?

I keep having to keep going into the "volume control" (pavucontrol) -> "Configuration" tab and change it from "Analog Stereo Output" to "Digital Stereo (HDMI) Output"

It may be doing this because it has an internal speaker.

I keep changing it HDMI after every reboot.

rbh

Moderator

From: South of Lapplands inland

Registered: 2016-08-11

Posts: 1,921

Re: Audio defaults to "Analog Stereo Output" after every reboot.

Have you read the thread  [SOLVED] Need to reset audio everytime I start in order to have sound and Set audio HDMI as default output?

Last edited by rbh (2020-03-25 00:58:07)

---

// Regards rbh

Please read before requesting help: "Guide to getting help", "Introduction to the Bunsenlabs Lithium Desktop" and other help topics under "Help & Resources" on the BunsenLabs menu

raksasas

New Member

Registered: 2015-10-22

Posts: 4

Re: Audio defaults to "Analog Stereo Output" after every reboot.

Have you read the thread  [SOLVED] Need to reset audio everytime I start in order to have sound and Set audio HDMI as default output?

They are a little confusing to follow.  I think I have picked them apart to get it worked out. I'll find out after a couple of reboots.